2008 Toyota Highlander - Do-It-Yourself Maintenance (69 pages)
Download Do-It-Yourself Maintenance
Manual Description
If you perform maintenance yourself, be sure follow correct, procedures as given these sections, toyota Super Long Life Coolant”, glycol based non-silicate, nonamine, non-nitrite non-borate.
Fuse with same amperage rating, the engine compartment contains many mechanisms fluids that may, move suddenly, become hot, or become electrically energized, or serious injury observe following precautions.
● Keep hands, clothing, and tools away from the moving fan engine, after driving as they may be hot, ● Do not leave anything that may burn easily, such as paper rags, ● Do not smoke, cause sparks or expose an open flame to fuel or the battery.
● Be extremely cautious when working on the battery, ● Take care because brake fluid can harm your hands eyes damage, if fluid gets on your hands or in your eyes, flush affected area with, if you still experience discomfort, see doctor.
The electric cooling fan may keep rotating for about 3 minutes even after, the ENGINE START STOP” switch or the engine switch OFF, with the ENGINE START STOP” switch or the engine switch ON, electric cooling fan may automatically start to run if air conditioning.
On and/or the coolant temperature is high, sTOP” switch or the engine switch is OFF when working near electric, wear safety glasses to prevent flying or falling material, fluid spray, etc, driving with the air cleaner removed may cause excessive engine wear due.
Release the lock from the inside of the vehicle open hood, the hood will pop up slightly, lift the hood catch lift, hold the hood open by inserting supporting rod into.
Check that the hood is fully closed locked, and cause an accident, which may result in death serious injury, after installing the support rod into slot, make sure the rod supports the hood securely from falling down your.
Be sure to return the support rod to its clip before closing hood, the hood with the support rod up could cause hood bend, when raising your vehicle with a floor jack, position the jack correctly, removing the front jack point cover.
Before jacking, remove jack point cover, make sure to observe the following to reduce the possibility of death serious injury, ● Lift up the vehicle using floor jack, such as the one shown illustration.
Always use automotive jack stands on solid, level surface, ● Stop the vehicle on level firm ground, firmly set the parking brake shift, ● Make sure to set the floor jack properly jack point, raising the vehicle with an improperly positioned floor jack will damage.
The vehicle and may cause the vehicle to fall off floor jack, ● When raising the vehicle, do not place any objects on top underneath, ● After installing the front jack point cover, make sure it is securely its original position, ● Before jacking up your vehicles, remove the front jack point cover.
With the engine at operating temperature and turned off, check oil, park the vehicle on level ground, wait a few minutes for the oil to drain back into bottom, hold a rag under end.
Holding a rag under the end, pull the dipstick out check, wipe the dipstick reinsert it fully, the low level mark, add engine.
Manual Description
If you perform maintenance yourself, be sure follow correct, procedures as given these sections, toyota Super Long Life Coolant”, glycol based non-silicate, nonamine, non-nitrite non-borate.
Fuse with same amperage rating, the engine compartment contains many mechanisms fluids that may, move suddenly, become hot, or become electrically energized, or serious injury observe following precautions.
● Keep hands, clothing, and tools away from the moving fan engine, after driving as they may be hot, ● Do not leave anything that may burn easily, such as paper rags, ● Do not smoke, cause sparks or expose an open flame to fuel or the battery.
● Be extremely cautious when working on the battery, ● Take care because brake fluid can harm your hands eyes damage, if fluid gets on your hands or in your eyes, flush affected area with, if you still experience discomfort, see doctor.
The electric cooling fan may keep rotating for about 3 minutes even after, the ENGINE START STOP” switch or the engine switch OFF, with the ENGINE START STOP” switch or the engine switch ON, electric cooling fan may automatically start to run if air conditioning.
On and/or the coolant temperature is high, sTOP” switch or the engine switch is OFF when working near electric, wear safety glasses to prevent flying or falling material, fluid spray, etc, driving with the air cleaner removed may cause excessive engine wear due.
Release the lock from the inside of the vehicle open hood, the hood will pop up slightly, lift the hood catch lift, hold the hood open by inserting supporting rod into.
Check that the hood is fully closed locked, and cause an accident, which may result in death serious injury, after installing the support rod into slot, make sure the rod supports the hood securely from falling down your.
Be sure to return the support rod to its clip before closing hood, the hood with the support rod up could cause hood bend, when raising your vehicle with a floor jack, position the jack correctly, removing the front jack point cover.
Before jacking, remove jack point cover, make sure to observe the following to reduce the possibility of death serious injury, ● Lift up the vehicle using floor jack, such as the one shown illustration.
Always use automotive jack stands on solid, level surface, ● Stop the vehicle on level firm ground, firmly set the parking brake shift, ● Make sure to set the floor jack properly jack point, raising the vehicle with an improperly positioned floor jack will damage.
The vehicle and may cause the vehicle to fall off floor jack, ● When raising the vehicle, do not place any objects on top underneath, ● After installing the front jack point cover, make sure it is securely its original position, ● Before jacking up your vehicles, remove the front jack point cover.
With the engine at operating temperature and turned off, check oil, park the vehicle on level ground, wait a few minutes for the oil to drain back into bottom, hold a rag under end.
Holding a rag under the end, pull the dipstick out check, wipe the dipstick reinsert it fully, the low level mark, add engine.
Toyota Models