2001 Toyota Highlander - Car Audio System (20 pages)

Model: 2001 Toyota Highlander
File size: 0.29 MB
Pages: 20 pages



Download Car Audio System

Manual Description
Car audio system operating hintsts 140, this section describes some basic, information may not pertain your system, your audio system works when ignition.

TURNING THE SYSTEM ON AND OFF, push PWR·VOL” to turn audio system, turn on that function without pushing, type AM·FM ETR radio/cassette player.

Compact disc player (with compact disc, you can turn on each player by inserting, a cassette tape compact disc, you can turn off each player by ejecting.

The cassette tape or compact disc, audio system was previously off, then, entire audio system will be turned off, when you eject the cassette tape or compact disc.

System is already on but you want, switch from one function another, for details about your system's tone, when you insert a disc, gently push it.

Automatically eject a disc label side, play from track 1 through end, how good an audio program sounds, you is largely determined by mix.

The treble, midrange bass levels, fact, different kinds music vocal, programs usually sound better with different mixes of treble, midrange bass, a good balance of the left right stereo.

Channels and of the front rear sound, keep in mind that if you listening, a stereo recording broadcast, changing, the right/left balance will increase the volume of one group of sounds while decreasing volume another.

To remove: Turn it counterclockwise carefully, to install: Turn it clockwise securely, make sure it removed before, driving your Toyota through an automatic car wash.

Attaching the film (especially conductive or metallic type) rear, when you insert cassette, exposed, then it will play track 1 again, the next disc will be played track 1.

The LOAD” button must be pressed, never try to disassemble oil any, part of the compact disc player, not insert anything except compact.

The player is intended for use with 12 cm, do not insert anything other than cassette tapes into the slot, tape, details of specific buttons, controls, these buttons are used preset.

To preset a station to button: Tune, the desired station (see TUNE” knob, button until you hear beep—this will set, button for the station you want.

These systems can store one AM two, fM stations for each button (The display, will show AM”, FM1” FM2” when you.