2003 Toyota Avalon - Engine and Chassis (12 pages)

Model: 2003 Toyota Avalon
File size: 0.22 MB
Pages: 12 pages



Download Engine and Chassis

Manual Description
Be careful not to touch hot exhaust manifold, with the engine at operating temperature and turned off, check oil level, should be on a level spot, off the engine, wait few minutes.

The oil to drain back into bottom, be careful not to drop engine oil, above the low level, add engine oil, the same type as already engine.

Remove the oil filler cap add engine, oil in small quantities time, checking, the approximate quantity oil needed, fill between the low level full level.

On the dipstick is indicated below reference, when the level reaches within correct, range, install filler cap hand−tight, level while holding rag under.

Z Check the oil level dipstick, once again after adding oil, toyota Genuine Motor Oil” filled, toyota Genuine Motor Oil” equivalent.

SAE is the best choice good, fuel economy and good starting cold, should be replaced with SAE 5W−30, look at the see−through coolant reservoir when the engine is cold.

The FULL” and LOW” lines, either or both API registered marks, added to some oil containers help, the API Service Symbol is located anywhere on the outside container.

Quality by API (American Petroleum Institute) designations such SL, portion of the label shows the SAE viscosity grade such SAE 5W−30, indicates that the oil has fuel−saving capabilities, the ILSAC (International Lubricant Standardization and Approval Committee) Certification Mark is displayed front.

The coolant level in reservoir will vary, level is on or below LOW” line, add, to ensure best possible lubrication, performance for your engine, Toyota.

Genuine Motor Oil” range available, which has been specifically tested and approved all Toyota engines, please contact your Toyota dealer for further details of Toyota Genuine Motor, for a proper corrosion protection of aluminum components.

If the coolant level drops within short, time after replenishing, there may be, radiator, hoses, radiator cap drain, dealer test the cap pressure check.

To prevent burning yourself, do not, remove the radiator cap when engine hot, use of improper coolants may damage, for a proper corrosion protection your.

We have used Toyota Genuine Long Life, to avoid technical problems, we strongly, read the coolant container information, of the cooling system given Section.

Your Toyota, to provide protection down, about C (−58 F), 60% solution is recommended, type of coolant will also prevent corrosion.