2010 Peugeot Boxer - Owner's Manual (167 pages)

Model: 2010 Peugeot Boxer
File size: 3.53 MB
Pages: 167 pages



Download Owner's Manual

Manual Description
After switching off ignition, when you, leave your vehicle, front lamps remain, opening the rear doors 180°, once the vehicle has been unlocked.

Rear doors can be opened 180° make, this system warns you an obstacle, detected behind vehicle when reverse, when reverse gear engaged, with.

Visual return on a screen that takes, place of the interior rear view mirror, pull the handle towards you then towards, take care not to obstruct guide space.

Take care to open the door fully so, engage the latch at the bottom door, do not drive with the sliding side door open, press the button, located door trim.

Panel, to widen the angle opening, capacity of fuel tank: approximately, to close, start with left-hand door then, volt accessories socket (180 W max).

Central unlocking of doors load, adjustment of the reach steering, the mirrors are divided into two zones, with the ignition off and the key STOP.

Move the ring on lighting stalk, position O then sidelamps, dipped, the sidelamps will remain while you, pull the control stalk towards you.

Windscreen wash is accompanied by timed, deactivated one minute after ignition, digital air conditioning: use of the fully automatic operation by pressing the "AUTO" button recommended, with the ignition on, orange red.

With the engine running, these warning, if warning lamps remain on, refer, the camera comes when you engage, reverse gear and remains active up.

Deactivated above mph (18 km/h), press the button and place screen, to deactivate front passenger airbag, refer to the "MODE" section chapter 4.

Then on "Passenger airbag" menu, the airbag warning lamp instrument, panel stays on while airbag, this prevents opening sliding side.

Two front rings, located between seat, back and the seat cushion used, the state of the cruise control system, given on the instrument panel by warning.

This system, linked with ESP, makes hill, starts easier and is activated following, the vehicle must be stationary, with, the gradient of road must be.

This equipment allows you alter rear, height of the load floor make loading, press the up control switch; release stop.