2003 Nissan Xterra - Audio Visual System (Section AV) (18 pages)

Model: 2003 Nissan Xterra
File size: 0.43 MB
Pages: 18 pages



Download Audio Visual System (Section AV)

Manual Description
(SRS) AIR BAG” and SEAT BELT PRE-TENSIONER” 2, wiring Diagrams Trouble Diagnosis 2, mODELS WITH AUDIO AMPLIFIER AND SUBWOOFER 3, wITH AUDIO AMPLIFIER AND SUBWOOFER 6.

Wiring Diagram — AUDIO — 7, aUDIO UNIT (WITHOUT AUDIO AMPLIFIER) 14, aUDIO UNIT (WITH AUDIO AMPLIFIER) 14, aUDIO UNIT (WITH AUDIO AMPLIFIER AND.

Precautions for Supplemental Restraint System (SRS) AIR BAG” SEAT, the Supplemental Restraint System such as AIR BAG” and SEAT BELT PRE-TENSIONER”, used along, with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger certain, system uses the seat belt switches to determine the front air bag deployment, and may only deploy one front.

Air bag, depending on the severity of a collision and whether the front occupants belted unbelted, information necessary to service the system safely is included in the SRS and SB section Service Manual, to avoid rendering the SRS inoperative, which could increase the risk of personal injury death, improper maintenance, including incorrect removal and installation of the SRS, can lead to personal injury caused by unintentional activation of the system.

Do not use electrical test equipment on any circuit related to the SRS unless instructed, when you read wiring diagrams, refer following, "POWER SUPPLY ROUTING" power distribution circuit, when you perform trouble diagnosis, refer following.

"HOW TO FOLLOW TEST GROUPS IN TROUBLE DIAGNOSES", "How to Perform Efficient Diagnosis an Electrical Incident", check for any Service bulletins before servicing vehicle, refer to Owner's Manual for audio system operating instructions.

Power is supplied all times, with the ignition switch in the ACC or ON position, power supplied, ground is supplied through the case audio unit, when the audio unit power knob is pushed to the ON position, audio signals supplied.

Through audio unit terminals 2, 4, 14 16, to door speakers, pillar tweeters rear speakers, through fusible link (letter h, located in the fuse fusible link box), to audio amplifier terminals 5 12.

Ground for the audio unit is supplied through the case of the audio unit, through audio unit terminals 1, 2, 3, 4, 13, 14, 15 16, to audio amplifier terminals 15, 16, 17, 20, 21, 22, 23, 24, through audio amplifier terminals 1, 2, 3, 9.

To front door speakers, pillar tweeters rear speakers, when the steering switch is pushed, audio signals supplied, to steering wheel audio control switch terminal 15, through steering wheel audio control switch terminal 16.

MODELS WITH AUDIO AMPLIFIER AND SUBWOOFER, to front door speakers, pillar tweeters and rear speaker RH subwoofer, turn ignition switch ON and verify that battery positive, voltage is present at terminal 10 audio unit.

Link box) and verify that battery positive voltage, present at terminal 6 audio unit, between audio unit audio amplifier, between audio amplifier each speaker.

Steering wheel audio control switch does not operate, aUDIO UNIT (WITH AUDIO AMPLIFIER AND SUBWOOFER), between audio amplifier and each speaker subwoofer, measure the resistance between speaker terminals + –.

Q The resistance should be 2 - 4Ω, using jumper wires, momentarily connect a 9V battery between speaker terminals + –, using a jumper wire, clip an auxiliary ground between antenna body.