2014 Nissan Juke - Roof (Section RF) (45 pages)
Download Roof (Section RF)
Manual Description
BODY EXTERIOR, DOORS, ROOF & VEHICLE SECURITY, (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" 3, precaution for Procedure without Cowl Top Cover 3, precautions for Removing Battery Terminal 4.
CONTROL UNIT : Special Repair Requirement17, pOWER SUPPLY AND GROUND CIRCUIT 18, sUNROOF DOES NOT OPERATE PROPERLY 23, aUTO OPERATION DOES NOT OPERATE 25.
SUNROOF DOES NOT OPERATE ANTIPINCH FUNCTION 26, sQUEAK AND RATTLE TROUBLE DIAGNOSES 28, precaution for Supplemental Restraint System (SRS) "AIR BAG" "SEAT BELT, the Supplemental Restraint System such as AIR BAG” and SEAT BELT PRE-TENSIONER”, used along.
With a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger certain, system uses the seat belt switches to determine the front air bag deployment, and may only deploy one front, air bag, depending on the severity of a collision and whether the front occupants belted unbelted, information necessary to service the system safely is included in the SRS AIR BAG” and SEAT BELT”.
Always observe the following items preventing accidental activation, to avoid rendering the SRS inoperative, which could increase the risk of personal injury death, the event of a collision that would result in air bag inflation, all maintenance must be performed by, improper maintenance, including incorrect removal and installation of the SRS, can lead personal.
Injury caused by unintentional activation of the system, never use electrical test equipment on any circuit related to the SRS unless instructed to in this Service Manual, pRECAUTIONS WHEN USING POWER TOOLS (AIR OR ELECTRIC) AND HAMMERS, when working near the Air Bag Diagnosis Sensor Unit or other Air Bag System sensors with.
Ignition ON or engine running, never use air or electric power tools or strike near sensor(s) with, when using air or electric power tools or hammers, always switch the ignition OFF, disconnect, battery, and wait at least 3 minutes before performing any service, precaution for Procedure without Cowl Top Cover.
When performing the procedure after removing cowl top cover, cover, the lower end of windshield with urethane, etc prevent damage, precautions for Removing Battery Terminal, when removing the 12V battery terminal, turn OFF ignition.
Switch and wait least 30 seconds, stops, then a DTC detection error or ECU data corruption may, for vehicles with the 2-batteries, be sure to connect the main battery and the sub battery before turning ON ignition switch, if the ignition switch is turned ON with any one terminals.
Main battery and sub battery disconnected, then DTC may be, after installing the 12V battery, always check "Self Diagnosis Result" of all ECUs erase DTC, the removal of 12V battery may cause DTC detection error, the actual shapes of Kent-Moore tools may differ from those of special service tools illustrated here.
Removes the clips, pawls metal clips, supplies the power supply sunroof motor assembly, transmits vehicle speed signal sunroof motor assembly, detects door open/close condition transmits BCM.
It is sunroof motor and CPU integrated type that enables tilt up/down & slide open/close by sunroof switch operation, transmits tilt up/down & slides open/close operation signal sunroof motor assembly, sunroof motor assembly operates with the power supply that is output from BCM while ignition switch ON, tilt up/down & slide open/close signals from sunroof switch enables operate sunroof motor move arbitrarily.
Sunroof motor assembly receives a vehicle speed signal from combination meter controls sunroof, the sunroof operate to the following condition by sunroof switch operation, sunroof AUTO feature makes it possible to slide open and slide close or tilt up and tilt down the sunroof without holding the sunroof switch in the slide open/tilt down or slide close/tilt up position, retained power operation is an additional power supply function that enables sunroof system to operate during 45 seconds even when ignition switch turned OFF.
Front door CLOSE (door switch OFF)→OPEN (door switch ON), when ignition switch ON again, the CPU of sunroof motor assembly monitors the sunroof motor operation and the sunroof position (fullyclosed or other) by the signals sunroof motor.
Manual Description
BODY EXTERIOR, DOORS, ROOF & VEHICLE SECURITY, (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" 3, precaution for Procedure without Cowl Top Cover 3, precautions for Removing Battery Terminal 4.
CONTROL UNIT : Special Repair Requirement17, pOWER SUPPLY AND GROUND CIRCUIT 18, sUNROOF DOES NOT OPERATE PROPERLY 23, aUTO OPERATION DOES NOT OPERATE 25.
SUNROOF DOES NOT OPERATE ANTIPINCH FUNCTION 26, sQUEAK AND RATTLE TROUBLE DIAGNOSES 28, precaution for Supplemental Restraint System (SRS) "AIR BAG" "SEAT BELT, the Supplemental Restraint System such as AIR BAG” and SEAT BELT PRE-TENSIONER”, used along.
With a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger certain, system uses the seat belt switches to determine the front air bag deployment, and may only deploy one front, air bag, depending on the severity of a collision and whether the front occupants belted unbelted, information necessary to service the system safely is included in the SRS AIR BAG” and SEAT BELT”.
Always observe the following items preventing accidental activation, to avoid rendering the SRS inoperative, which could increase the risk of personal injury death, the event of a collision that would result in air bag inflation, all maintenance must be performed by, improper maintenance, including incorrect removal and installation of the SRS, can lead personal.
Injury caused by unintentional activation of the system, never use electrical test equipment on any circuit related to the SRS unless instructed to in this Service Manual, pRECAUTIONS WHEN USING POWER TOOLS (AIR OR ELECTRIC) AND HAMMERS, when working near the Air Bag Diagnosis Sensor Unit or other Air Bag System sensors with.
Ignition ON or engine running, never use air or electric power tools or strike near sensor(s) with, when using air or electric power tools or hammers, always switch the ignition OFF, disconnect, battery, and wait at least 3 minutes before performing any service, precaution for Procedure without Cowl Top Cover.
When performing the procedure after removing cowl top cover, cover, the lower end of windshield with urethane, etc prevent damage, precautions for Removing Battery Terminal, when removing the 12V battery terminal, turn OFF ignition.
Switch and wait least 30 seconds, stops, then a DTC detection error or ECU data corruption may, for vehicles with the 2-batteries, be sure to connect the main battery and the sub battery before turning ON ignition switch, if the ignition switch is turned ON with any one terminals.
Main battery and sub battery disconnected, then DTC may be, after installing the 12V battery, always check "Self Diagnosis Result" of all ECUs erase DTC, the removal of 12V battery may cause DTC detection error, the actual shapes of Kent-Moore tools may differ from those of special service tools illustrated here.
Removes the clips, pawls metal clips, supplies the power supply sunroof motor assembly, transmits vehicle speed signal sunroof motor assembly, detects door open/close condition transmits BCM.
It is sunroof motor and CPU integrated type that enables tilt up/down & slide open/close by sunroof switch operation, transmits tilt up/down & slides open/close operation signal sunroof motor assembly, sunroof motor assembly operates with the power supply that is output from BCM while ignition switch ON, tilt up/down & slide open/close signals from sunroof switch enables operate sunroof motor move arbitrarily.
Sunroof motor assembly receives a vehicle speed signal from combination meter controls sunroof, the sunroof operate to the following condition by sunroof switch operation, sunroof AUTO feature makes it possible to slide open and slide close or tilt up and tilt down the sunroof without holding the sunroof switch in the slide open/tilt down or slide close/tilt up position, retained power operation is an additional power supply function that enables sunroof system to operate during 45 seconds even when ignition switch turned OFF.
Front door CLOSE (door switch OFF)→OPEN (door switch ON), when ignition switch ON again, the CPU of sunroof motor assembly monitors the sunroof motor operation and the sunroof position (fullyclosed or other) by the signals sunroof motor.
Nissan Models