2005 Nissan Altima - Rear Axle (Section RAX) (8 pages)
Download Rear Axle (Section RAX)
Manual Description
SERVICE DATA AND SPECIFICATIONS (SDS) 8, when installing each rubber part, final tightening must be, carried out under unladen condition* with tires ground, *: Fuel, radiator coolant and engine oil full.
Hand tools and mats designated positions, use flare nut wrench when removing installing brake, after installing removed suspension parts, check wheel, always torque brake lines when installing.
The actual shapes of Kent-Moore tools may differ from those of special service tools illustrated here, nOISE, VIBRATION, AND HARSHNESS(NVH) TROUBLESHOOTING, use the chart below to help you find the cause of the symptom, check axle and suspension parts for excessive play, wear damage.
Shake each rear wheel to check excessive play, check that wheel hub bearings operate smoothly, replace wheel bearing assembly if there is axial end play, wheel bearing does not turn smoothly.
Wheel hub assembly does not require maintenance, a growling noise is emitted from the wheel hub assembly while driving, the wheel hub assembly drags turns roughly, q The brake hose does not need to be disconnected brake caliper.
Q Suspend the brake caliper assembly using wire, do not stretch brake hose, remove the rear ABS sensor, then move it away from wheel hub assembly, failure to remove the ABS sensor may result in damage to the sensor wires sensor being, remove the wheel hub assembly knuckle.
Check for any deformity, cracks, or damage on the wheel hub assembly, replace necessary, installation is in the reverse order removal, check that the wheel bearings operate smoothly, check that the wheel hub bearing axial end play within specification.
SERVICE DATA AND SPECIFICATIONS (SDS)...
Manual Description
SERVICE DATA AND SPECIFICATIONS (SDS) 8, when installing each rubber part, final tightening must be, carried out under unladen condition* with tires ground, *: Fuel, radiator coolant and engine oil full.
Hand tools and mats designated positions, use flare nut wrench when removing installing brake, after installing removed suspension parts, check wheel, always torque brake lines when installing.
The actual shapes of Kent-Moore tools may differ from those of special service tools illustrated here, nOISE, VIBRATION, AND HARSHNESS(NVH) TROUBLESHOOTING, use the chart below to help you find the cause of the symptom, check axle and suspension parts for excessive play, wear damage.
Shake each rear wheel to check excessive play, check that wheel hub bearings operate smoothly, replace wheel bearing assembly if there is axial end play, wheel bearing does not turn smoothly.
Wheel hub assembly does not require maintenance, a growling noise is emitted from the wheel hub assembly while driving, the wheel hub assembly drags turns roughly, q The brake hose does not need to be disconnected brake caliper.
Q Suspend the brake caliper assembly using wire, do not stretch brake hose, remove the rear ABS sensor, then move it away from wheel hub assembly, failure to remove the ABS sensor may result in damage to the sensor wires sensor being, remove the wheel hub assembly knuckle.
Check for any deformity, cracks, or damage on the wheel hub assembly, replace necessary, installation is in the reverse order removal, check that the wheel bearings operate smoothly, check that the wheel hub bearing axial end play within specification.
SERVICE DATA AND SPECIFICATIONS (SDS)...
Nissan Models