2011 Nissan 370Z - Power Supply, Ground & Circuit Elements (Section PG) (120 pages)
Download Power Supply, Ground & Circuit Elements (Section PG)
Manual Description
POWER SUPPLY, GROUND & CIRCUIT ELEMENTS, wiring Diagram - BATTERY POWER SUPPLY - 6, wiring Diagram - BATTERY POWER SUPPLY, wiring Diagram - ACCESSORY POWER SUPPLY - 45.
Wiring Diagram - ACCESSORY POWER SUPPLY FUSE No, wiring Diagram - IGNITION POWER SUPPLY - 53, wiring Diagram - IGNITION POWER SUPPLY, fUSE BLOCK - JUNCTION BOX (J/B) 112.
Fuse, Connector Terminal Arrangement 112, fUSE, FUSIBLE LINK AND RELAY BOX 113, fuse and Fusible Link Arrangement 113, iPDM E/R (INTELLIGENT POWER DISTRIBUTION MODULE ENGINE ROOM) 114.
Fuse, Connector Terminal Arrangement 114, fOR MEXICO : Precaution for Supplemental Restraint System (SRS) "AIR BAG" "SEAT BELT, fOR MEXICO : Precaution Battery Service116, fOR MEXICO : Precaution Procedure without.
BATTERY TERMINAL WITH FUSIBLE LINK 119, if it becomes necessary to start the engine with a booster battery and jumper cables, use 12-volt, after connecting battery cables, ensure that they are tightly clamped to battery terminals good, never add distilled water through the hole used check specific gravity.
The following precautions must be taken to prevent over-discharging battery, the battery surface (particularly its top) should always be kept, the terminal connections should be clean tight, at every routine maintenance, check electrolyte level.
This also applies to batteries designated low maintenance”, when the vehicle is not going to be used over long period, time, disconnect the battery cable from negative terminal, the vehicle has an extended storage switch, turn it off.
Check the charge condition battery, periodically check the specific gravity of electrolyte, close check on charge condition prevent over-discharge, never allow battery fluid to come in contact with skin, eyes, fabrics, or painted surfaces.
Remove the cell plug using suitable tool, add distilled water up MAX level, a battery will be completely discharged if it left unattended, for a long time and the specific gravity will become less than.
To determine if a battery has been sulphated”, note its voltage, a sulphated battery may sometimes be brought back into service by means of a long, slow charge, 12 hours or more, followed by battery capacity test, read hydrometer and thermometer indications eye level, use the chart below to correct your hydrometer reading according electrolyte temperature.
Never quick charge” fully discharged battery, keep the battery away from open flame while it being charged, when connecting the charger, connect the leads first, then turn on the charger, charger first, as this may cause spark.
If battery electrolyte temperature rises above 55 °C (131 °F), stop charging, a temperature below 55 °C (131 °F), do not charge at more than 50 ampere rate, the ammeter reading on your battery charger will automatically decrease as the battery charges.
Indicated above refer initial charge rate, if, after charging, the specific gravity of any two cells varies more than 0, tROUBLE DIAGNOSIS WITH BATTERY SERVICE CENTER, for battery testing, use Battery Service Center (J-48087).
Nical Service Bulletin and/or Battery Service Center User Guide, wiring Diagram - BATTERY POWER SUPPLY , wiring Diagram - BATTERY POWER SUPPLY FUSE No.
Manual Description
POWER SUPPLY, GROUND & CIRCUIT ELEMENTS, wiring Diagram - BATTERY POWER SUPPLY - 6, wiring Diagram - BATTERY POWER SUPPLY, wiring Diagram - ACCESSORY POWER SUPPLY - 45.
Wiring Diagram - ACCESSORY POWER SUPPLY FUSE No, wiring Diagram - IGNITION POWER SUPPLY - 53, wiring Diagram - IGNITION POWER SUPPLY, fUSE BLOCK - JUNCTION BOX (J/B) 112.
Fuse, Connector Terminal Arrangement 112, fUSE, FUSIBLE LINK AND RELAY BOX 113, fuse and Fusible Link Arrangement 113, iPDM E/R (INTELLIGENT POWER DISTRIBUTION MODULE ENGINE ROOM) 114.
Fuse, Connector Terminal Arrangement 114, fOR MEXICO : Precaution for Supplemental Restraint System (SRS) "AIR BAG" "SEAT BELT, fOR MEXICO : Precaution Battery Service116, fOR MEXICO : Precaution Procedure without.
BATTERY TERMINAL WITH FUSIBLE LINK 119, if it becomes necessary to start the engine with a booster battery and jumper cables, use 12-volt, after connecting battery cables, ensure that they are tightly clamped to battery terminals good, never add distilled water through the hole used check specific gravity.
The following precautions must be taken to prevent over-discharging battery, the battery surface (particularly its top) should always be kept, the terminal connections should be clean tight, at every routine maintenance, check electrolyte level.
This also applies to batteries designated low maintenance”, when the vehicle is not going to be used over long period, time, disconnect the battery cable from negative terminal, the vehicle has an extended storage switch, turn it off.
Check the charge condition battery, periodically check the specific gravity of electrolyte, close check on charge condition prevent over-discharge, never allow battery fluid to come in contact with skin, eyes, fabrics, or painted surfaces.
Remove the cell plug using suitable tool, add distilled water up MAX level, a battery will be completely discharged if it left unattended, for a long time and the specific gravity will become less than.
To determine if a battery has been sulphated”, note its voltage, a sulphated battery may sometimes be brought back into service by means of a long, slow charge, 12 hours or more, followed by battery capacity test, read hydrometer and thermometer indications eye level, use the chart below to correct your hydrometer reading according electrolyte temperature.
Never quick charge” fully discharged battery, keep the battery away from open flame while it being charged, when connecting the charger, connect the leads first, then turn on the charger, charger first, as this may cause spark.
If battery electrolyte temperature rises above 55 °C (131 °F), stop charging, a temperature below 55 °C (131 °F), do not charge at more than 50 ampere rate, the ammeter reading on your battery charger will automatically decrease as the battery charges.
Indicated above refer initial charge rate, if, after charging, the specific gravity of any two cells varies more than 0, tROUBLE DIAGNOSIS WITH BATTERY SERVICE CENTER, for battery testing, use Battery Service Center (J-48087).
Nical Service Bulletin and/or Battery Service Center User Guide, wiring Diagram - BATTERY POWER SUPPLY , wiring Diagram - BATTERY POWER SUPPLY FUSE No.
Nissan Models