2013 Mazda Mazda 6 - Smart Start Guide (18 pages)

Model: 2013 Mazda Mazda 6
File size: 5.1 MB
Pages: 18 pages



Download Smart Start Guide

Manual Description
 his system allows you lock, unlock the doors, open trunk, lid and start engine without, this system remotely locks and unlocks the doors trunk.

Push & fold retract key,  nlock driver's door by, door handle after beep sound, side of the door handle will sense.

The motion of your hand unlock, nOTE: If the door handle pulled too, quickly (before door unlocked), door,  nlock all doors by pushing.

The inner door lock switch after, push and hold open trunk,  o start engine, locate the key slot cover on steering column, nsert the auxiliary key into the key slot, then push START/STOP.

Button with the clutch pedal (M/T) or the brake pedal (A/T) pushed down, start the engine by pushing START/STOP button, while, pushing the clutch pedal (manual transmission) brake pedal, shut the engine OFF by pushing START/STOP button again.

Activate Accessories (ACC) by pushing START/STOP button, once without pushing the clutch brake pedal, will show green when advanced key, is detected and the brake pedal is pushed.

The indicator flashes red (for 3 seconds) when the key not detected, or if the advanced keyless transmitter battery dead, red, the push button start may not start engine, unless, genuine Mazda Accessories are built to the same standards quality.

From a wide range of interior and exterior accessories make your, fit your personality and lifestyle, personalize your with the following Genuine Mazda Accessories, continuously pushing the START/STOP button while the engine running will.

If the advanced key cannot be used due to a malfunction dead advanced key, battery, use the auxiliary key to lock/unlock the doors and start engine, seat can be moved back forth, raised, lowered, or tilted with control.

(located on floor next driver's seat), to open, pull remote fuel, filler cap tether over hook, to Program Driver's Seat Position.

 djust seat to desired position using the slide/tilt recline switches, while pushing the memory seat SET button, push one three, programming buttons until a beep is heard, nOTE: You can also program one seat position each advanced key/retractable.

Type key used with the vehicle, to Move the Seat Programmed Position,  ith driver's door OPEN and ignition OFF, push release one, of the programmed buttons (1, 2, or 3) when entering vehicle.

 ith driver's door CLOSED and ignition ON, push hold one, the programmed buttons (1, 2, 3), nOTE: Memory seat functions DO NOT operate when driver's door OPEN, ignition is ON, when driver's door is CLOSED and ignition is OFF, when vehicle.

Driver's View (shown with optional, this indicator light illuminates to remind you that the front passenger's front/side airbags seat belt, pretensioner will not deploy during a collision.