2004 Infiniti QX56 - Supplemental Restraint System (Section SRS) (64 pages)
Download Supplemental Restraint System (Section SRS)
Manual Description
(SRS) AIR BAG” and SEAT BELT PRE-TENSIONER” 3, precautions for SRS AIR BAG” SEAT BELT, front Seat Belt Pre-tensioner with Load Limiter 6, fOR QUICK AND ACCURATE REPAIR 8.
Wiring Diagram — SRS — 12, hOW TO ERASE SELF-DIAGNOSIS RESULTS 19, hOW TO CHANGE SELF-DIAGNOSIS MODE 19, hOW TO ERASE SELF-DIAGNOSIS RESULTS 20.
WARNING LAMP FLASH CODE CHART 38, trouble Diagnosis: AIR BAG” Warning Lamp Does, fRONT PASSENGER AIR BAG MODULE 50, sIDE CURTAIN AIR BAG MODULE 53.
SIDE AIR BAG (SATELLITE) SENSOR 56, oCCUPANT CLASSIFICATION SYSTEM CONTROL UNIT 59, sRS INSPECTION (FOR FRONTAL COLLISION) 60, wHEN SRS IS ACTIVATED IN THE SIDE COLLISION61.
WHEN SRS IS NOT ACTIVATED IN THE SIDE, wHEN SRS IS ACTIVATED IN THE ROLLOVER62, wHEN SRS IS NOT ACTIVATED IN THE ROLLOVER62, precautions for Supplemental Restraint System (SRS) AIR BAG” SEAT.
The Supplemental Restraint System such as AIR BAG” and SEAT BELT PRE-TENSIONER”, used along, with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger certain, system uses the seat belt switches to determine the front air bag deployment, and may only deploy one front, air bag, depending on the severity of a collision and whether the front occupants belted unbelted.
Information necessary to service the system safely is included in the SRS and SB section Service Manual, to avoid rendering the SRS inoperative, which could increase the risk of personal injury death, improper maintenance, including incorrect removal and installation of the SRS, can lead to personal injury caused by unintentional activation of the system, do not use electrical test equipment on any circuit related to the SRS unless instructed.
Precautions for SRS AIR BAG” and SEAT BELT PRE-TENSIONER” Service, do not use electrical test equipment to check SRS circuits unless instructed to Service Manual, before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait least 3 minutes, for approximately minutes after the cables are removed, it is still possible for the air bag seat belt.
The air bag diagnosis sensor unit must always be installed with the arrow mark ⇐” pointing toward, front of the vehicle for proper operation, rust before installation replace required, the spiral cable must be aligned with the neutral position since its rotations are limited.
Turn steering wheel or column after removal steering gear, side facing upward and seat mounted front side air bag module standing with the stud bolt side facing, conduct self-diagnosis to check entire SRS for proper function after replacing any components, after air bag inflates, the front instrument panel assembly should be replaced damaged.
Replace control unit and passenger front seat cushion an assembly, when you read wiring diagrams, refer following, "How to Read Wiring Diagrams" GI section, "POWER SUPPLY ROUTING CIRCUIT" PG section.
When you perform trouble diagnosis, refer following, "HOW TO FOLLOW TEST GROUPS IN TROUBLE DIAGNOSES" GI section, "How to Perform Efficient Diagnosis for an Electrical Incident" GI section, check for any service bulletins before servicing vehicle.
The actual shapes of Kent-Moore tools may differ from those of special service tools illustrated here, removing and installing air bag lock, the collision modes for which supplemental restraint systems are activated are different among the SRS systems, and front seat belt buckle pre-tensioners are activated in a frontal collision but not side collision.
SRS configurations for some collision modes follows, front LH seat belt buckle pre-tensioner assembly, front RH seat belt buckle pre-tensioner assembly.
Manual Description
(SRS) AIR BAG” and SEAT BELT PRE-TENSIONER” 3, precautions for SRS AIR BAG” SEAT BELT, front Seat Belt Pre-tensioner with Load Limiter 6, fOR QUICK AND ACCURATE REPAIR 8.
Wiring Diagram — SRS — 12, hOW TO ERASE SELF-DIAGNOSIS RESULTS 19, hOW TO CHANGE SELF-DIAGNOSIS MODE 19, hOW TO ERASE SELF-DIAGNOSIS RESULTS 20.
WARNING LAMP FLASH CODE CHART 38, trouble Diagnosis: AIR BAG” Warning Lamp Does, fRONT PASSENGER AIR BAG MODULE 50, sIDE CURTAIN AIR BAG MODULE 53.
SIDE AIR BAG (SATELLITE) SENSOR 56, oCCUPANT CLASSIFICATION SYSTEM CONTROL UNIT 59, sRS INSPECTION (FOR FRONTAL COLLISION) 60, wHEN SRS IS ACTIVATED IN THE SIDE COLLISION61.
WHEN SRS IS NOT ACTIVATED IN THE SIDE, wHEN SRS IS ACTIVATED IN THE ROLLOVER62, wHEN SRS IS NOT ACTIVATED IN THE ROLLOVER62, precautions for Supplemental Restraint System (SRS) AIR BAG” SEAT.
The Supplemental Restraint System such as AIR BAG” and SEAT BELT PRE-TENSIONER”, used along, with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger certain, system uses the seat belt switches to determine the front air bag deployment, and may only deploy one front, air bag, depending on the severity of a collision and whether the front occupants belted unbelted.
Information necessary to service the system safely is included in the SRS and SB section Service Manual, to avoid rendering the SRS inoperative, which could increase the risk of personal injury death, improper maintenance, including incorrect removal and installation of the SRS, can lead to personal injury caused by unintentional activation of the system, do not use electrical test equipment on any circuit related to the SRS unless instructed.
Precautions for SRS AIR BAG” and SEAT BELT PRE-TENSIONER” Service, do not use electrical test equipment to check SRS circuits unless instructed to Service Manual, before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait least 3 minutes, for approximately minutes after the cables are removed, it is still possible for the air bag seat belt.
The air bag diagnosis sensor unit must always be installed with the arrow mark ⇐” pointing toward, front of the vehicle for proper operation, rust before installation replace required, the spiral cable must be aligned with the neutral position since its rotations are limited.
Turn steering wheel or column after removal steering gear, side facing upward and seat mounted front side air bag module standing with the stud bolt side facing, conduct self-diagnosis to check entire SRS for proper function after replacing any components, after air bag inflates, the front instrument panel assembly should be replaced damaged.
Replace control unit and passenger front seat cushion an assembly, when you read wiring diagrams, refer following, "How to Read Wiring Diagrams" GI section, "POWER SUPPLY ROUTING CIRCUIT" PG section.
When you perform trouble diagnosis, refer following, "HOW TO FOLLOW TEST GROUPS IN TROUBLE DIAGNOSES" GI section, "How to Perform Efficient Diagnosis for an Electrical Incident" GI section, check for any service bulletins before servicing vehicle.
The actual shapes of Kent-Moore tools may differ from those of special service tools illustrated here, removing and installing air bag lock, the collision modes for which supplemental restraint systems are activated are different among the SRS systems, and front seat belt buckle pre-tensioners are activated in a frontal collision but not side collision.
SRS configurations for some collision modes follows, front LH seat belt buckle pre-tensioner assembly, front RH seat belt buckle pre-tensioner assembly.
Read(view) online free pdf manual 2004 Infiniti QX56
Infiniti Models